
A1 Low-Power IR Infrared Control Board Module for Sensor Sanitary Ware
Smart Kitchen & Bath · Solution A1 Low-Power IR Infrared Sensor Contr
Read moreInput Power: DC 6V / AC 110–220V
Activation Method: Top sensor, bottom sensor, and manual operation—switch freely among three modes
Operating Water Pressure:0.05–0.7 MPa
Standby Power Consumption:≤90 μA
Dynamic Power Consumption:≤3 W
Sensor Detection Range:Top sensor detection range: 8±2 cm (remotely adjustable); bottom sensor detection range: 27±3 cm (remotely adjustable)
Adjustment Method:Remote-Controlled Adjustment
Check Valve:Yes, effectively prevents cross flow between hot and cold
Power Failure Protection:Yes. In the event of a sudden power outage, the solenoid valve automatically closes.
Timeout Protection: Yes, auto shut-off protection after 3 minutes
Pressure Resistance Standard:16 kg/m
Waterproof Rating:IP65
Service Life:≥500,000 cycles
Applicable Standards:CJ/T 194-2004
Features
1. Top Sensor Function: Activate with one sensor wave, deactivate with a second; auto shut-off after 3 minutes if no further activation is detected
2. Front Sensor Function: Extend your hand to start water flow; withdraw to stop
Dual independent flow paths allow manual faucet operation during power outages or electrical faults without any intervention
2. Added instant sensor functionality for the convenience and comfort of a sensor kitchen faucet
Pull-down Kitchen Faucet, Single Cold Water Faucet, Thermostatic Mixing Valve with Recirculation

